ORBIS
[...]
Outstanding reliability in all harvesting conditions.
Efficient drive concept with 11% lower starting torque than comparable models
Unique crop flow for optimal chopping quality
Optimal ground-contour tracking with AUTO CONTOUR
Very low stubble height across the entire working width
Engage and reverse under full load
Straight-line crop transfer from ORBIS to JAGUAR for top chop quality
Uniform crop flow across the entire width of the feed roller housing
Extremely flat design for even stubble [...]
Jaguar (502) KP FINAL
pdf[...]
The chopping unit has the task of cutting the material
compressed by the feeder housing to the pre-set chopping length
and of accelerating this material out of the cutting plane.
There are 5 cylinder variants available:
• V20 (20 Knives)
• V24 (24 Knives)
• V28 (28 Knives)
• V36 (36 Knives)
• V42 (42 Knives)
27
1. The front attachment must remain on the feeder housing.
2. The feeder housing must first be lowered to the lowest
possible position.
3. Both drive shafts to the feeder gearbox can [...]
Jaguar (498) KP FINAL
pdf[...] sprockets are included in the shipping package
for adjusting the auger speed. These are 33 and 15
toothed sprockets for short chop lengths.
Auger speeds can further be adjusted by means of the 3
speed gearbox.
On the pick-up 300, the entire drive is from the mechanical
drive from the JAGUAR via quick coupler (1). From there,
the pick-up drive (2) and the feed auger (3) are driven.
Using the 3-speed gearbox (3) there is a shift lever which
enables the feed auger speed to be switched between
three gears [...]
Jaguar (500) KP FINAL
pdf[...]
2
1413
Feed Rollers
The purpose of the feed rollers is to compress the crop before it enters the chopping cylinder.
The feed roller speed is adjusted using the manual gearbox to achieve the required chop length.
Bottom Plate
When harvesting whole crop or maize,
the grain collection plate (1) needs to be
fitted underneath the feed rollers to stop
any grains from falling out under the machine.
This needs to be removed for grass harvesting.
Plastic Strips
It is advisable to remove the Teflon strips [...]
Jaguar (496) KP FINAL
pdf[...] Rollers
The purpose of the feed rollers is to compress the crop before it enters the chopping cylinder.
The feed roller speed is adjusted using the manual gearbox to achieve the required chop length.
Cylinder
V-Classic 14
Number of knives 28
3.5 - 15
24
4 - 17
20
5 - 21
Number of knives
Number of knives
Length of cut range (mm)
Length of cut range (mm)
Length of cut range (mm)
V-Classic 12
V-Classic 10
Application Complete set of knives
16
Bottom Plate
When harvesting whole crop or maize [...]