Filter by:
Your selected filters:
11
TUCANO 400 - 300 Information & Basic Field Settings
pdf[...] in the operator’s manual are safe.
Read and observe the operator’s manual before starting work.
If you need help understanding the content, contact your local
CLAAS Dealer.
Overview: Safety
6
The height was
measured with
the necessary tyre
inflation pressure,
on solid ground.
With
650/75 R 32 172A8
and
500/70 R24 164A8
tyres.
A
Length with short grain tank unloading tube*
Applies to: Machine with APS threshing system 7900 mm
A
Length with short grain tank unloading tube*
Applies to: Machine [...]
12
TUCANO 500 Information & Basic Field Settings
pdf[...] in the operator’s manual are safe.
Read and observe the operator’s manual before starting work.
If you need help understanding the content, contact your local
CLAAS Dealer.
Overview: Safety
6
A Length with short grain tank unloading tube 7900 mm
B Length with long grain tank unloadingtube 8825 mm
C Length with extra long grain tank unloading tube 9300 mm
C Length with XL grain tank unloading tube (bolted) 9325 mm
D Length with XXL grain tank unloading tube 9932 mm
E Width of machine body withouttyres 300 mm [...]
13
LEXION Information & Basic Field Settings
pdf[...] condition and worn or damaged ones are either turned or replaced.
Back off the stationary knives until the desired chop length is met.
On machines equipped with Special Cut II choppers make sure that the fine chop step is only used when necessary.
On all chopper units make sure the belts are properly adjusted and the stops on the chopper drive belt are pushed up tight.
*
*
Settings aid
The following pages are designed as quick reference flow chart to aid with settings should you encounter problems during [...]
14
LEXION Information & Basic Field Settings
pdf[...] is the standard setting.
Adjust the stripper plates behind the auger.
Remove the intermediate retractable fingers along the length of the auger leaving just the middle ones.
Alter the height of the auger within the trough of the cutterbar. There should be a minimum gap of 20mm between the trough and the auger flights.
Alter the speed of the auger by swapping the sprocket on the LHS of the cutterbar (V750 & V900) or changing the optional gears inside the auger drive gearbox (V1050 & V1200).
Crop Wrapping Problems [...]
15
LEXION 620 - 670 Information & Basic Field Settings
pdf[...]
settings on the chopper. These
can either be done from CEBIS
or adjusted manually.
1. Stationary knives (in, half in or full in)
2. Fine chop step
Make sure the chopper blades are kept in good condition and worn
or damaged ones are either turned or replaced.
Back off the stationary knives until the desired chop length is met.
Make sure that the fine chop step is only used when necessary.
Adjust the shear 3 bar when fitting new blades and when chopping maize.
Make sure the hood has stopped moving before [...]
Page 3 of 6 (29 results)
