Filter by:
Your selected filters:
6
JAGUAR 900
[...] CUT, infinite chop length adjustment is possible across the entire chop length range from 5mm up to 26.5mm (with a V-MAX 20 chopping cylinder). The feed roller drive pump and motor are also now mounted on rubber bushes, which reduce vibration and noise.
In other updates to the chopping system, the V-MAX chopping cylinder also now features a new segmented mounting system for the blades. This not only makes it quicker and easier to change and set the blades, but also means it is simpler to change blade [...]
7
New ORBIS 900 with 3.0 m transport width and automatic transport protection
[...] lodged maize is to be harvested, side covers with a hydraulically driven lodged maize auger as well as lodged maize cones for the outer transport discs, an extended centre point and point extensions are available. Optional guide bracket extensions can be fitted when working in very tall maize.
The two-speed main gearbox makes it easy to adjust the speed of the cutting drums to different operating conditions, and the three speed feeder cone gearbox allows speed adjustment to suit different chop lengths. Where [...]
8
PDF
pdf
[...]
Features over and above the JAGUAR 800 series
Spout Pilot Control*
• Automatic parallel trailer filling
• Automatic spout parking for road transport
New VISTA cab
• Superb driver comfort
• CEBIS control system for increased accuracy
• Yield measuring and Telematics capability
• Comprehensive lighting package
Transverse mounted engine
• Easy service access
• Direct synchronised drive to the chopping system
Variable accelerator*
• Controlled using CEBIS
• Optimise blow according to crop and chop length [...]
9
LEXION 670 - 620 Information & Basic Field Settings
pdf[...] is monitored and displayed
on the bar display next to the returns
monitor. The returns monitor can be
adjusted in CEBIS.
1 2
2
1
TIP. The centre shaft of the auger
should always be visible.
37
Settings: Straw and Chaff Management
TIP. Make sure the chopper blades are kept in good condition and worn or
damaged ones are either turned or replaced.
TIP. Back off the stationary knives until the desired chop length is met.
TIP. On machines equipped with Special Cut II choppers make sure that
the fine [...]
10
LEXION 780 - 740 Information & Basic Field Settings
pdf[...] .
1 2
2
1
TIP. The centre shaft of the auger
should always be visible.
37
Settings: Straw and Chaff Management
TIP. Make sure the chopper blades are kept in good condition and worn or
damaged ones are either turned or replaced.
TIP. Back off the stationary knives until the desired chop length is met.
TIP. On machines equipped with Special Cut II choppers make sure that
the fine chop step is only used when necessary.
TIP. Make sure the hood has stopped
moving before releasing the switch [...]
Page 2 of 6 (29 results)
